IMCO General Construction, Inc. 8/28/2024

Section 00 72 00 GENERAL CONDITIONS City of Everett 00 72 00-7 June 2024 WFP Air Scour Blower Building Replacement Issued for Bid UP3813 Owner, or Owner’s Representative, or their related entities, any duty or authority to supervise or direct the performance of the Work or any duty or authority to undertake responsibility inconsistent with the provisions of the Contract Documents. 2.2. DIVISION OF SPECIFICATIONS AND DRAWINGS Specifications and Drawings are divided into groups for convenience. These divisions are not for the purpose of apportioning Work or responsibility for Work among Subcontractors, Suppliers and manufacturers. The Contractor is responsible for all Work shown or described, regardless of location(s) in the Contract Documents. 2.3. DISCREPANCIES IN SPECIFICATIONS AND DRAWINGS 2.3.1. Errors and Omissions If the Contractor, in the course of the Work, becomes aware of any errors or omissions in the Contract Documents or in the Owner's field work, he or she shall immediately inform the Owner’s Representative in writing. The Owner’s Representative will promptly review the matter and if he or she finds an error or omission has been made, then he or she will determine the corrective actions and advise the Contractor accordingly. If the corrective work associated with an error or omission significantly increases or decreases the amount of Work called for in the Contract, the Owner will issue an appropriate Change Order. After discovery by the Contractor of an error or omission, related work performed by the Contractor shall be done at its risk unless authorized by the Owner’s Representative and approved by the Owner. Omissions from the Drawings or Specifications or the misdescription of details of Work that are manifestly necessary to carry out the intent of the Drawings and Specifications, or that are customarily performed, shall not relieve the Contractor from performing such omitted or misdescribed details of the Work, but they shall be performed as if fully and correctly set forth and described in the Drawings and Specifications. 2.3.2. Conflicting Provisions Figure dimensions on drawings shall govern over scale dimensions and detail drawings shall govern over general drawings. In the event an item of Work is described differently in two or more locations on the Drawings and in the Specifications, the Contractor shall, upon request of the Owner’s Representative, submit in writing to the Owner’s Representative the description upon which the Contractor relied in preparing its Bid or laying out the Work. If the Owner’s Representative directs the Contractor to perform Work in a manner other than that contemplated by the Contractor in preparing its Bid or laying out the Work, Change Order procedures will be followed. In this event, the Contractor shall submit to the Owner’s Representative such supporting information, including bidding or layout documents, as may reasonably be necessary for the Owner’s Representative to determine whether the Contract Sum is increased, decreased or unchanged by the Change Order. 2.3.3. Utilities 2.3.3.1 General The Owner has endeavored to determine the existence of utilities at the Site of the Work from the records of the owners of known utilities in the vicinity of the Work. The positions of these utilities as derived from such records are shown on the Drawings. No excavations were made to verify the locations shown for underground utilities. The service connections to these utilities are not shown on the Drawings. It shall be the responsibility of the Contractor to determine the exact location of utilities and service connections thereto. Such field verification must be performed in sufficient time so as not to impede the progress of the Work or fabrication of materials to be incorporated into the Work. The Contractor shall call the Utility Location Request Center (one call center) for location of utilities in the field not less than two (2) nor more than (10) ten business days before the scheduled date of commencement of excavation. The Contractor shall