1816 112TH ST SE 2025-01-14 - Laserfiche WebLink

Resfeb PUMP MOTOR AND HIGH LIMIT THERMOSTAT RESET PUMP MOTOR RESET Explanations: The pump motor is equipped with a thermally activated switch. The purpose of this safety device is to cut the power of the pump motor in case the motor is over -heating (and causes fire hazard) due to several causes: 1. If discharge valve is not In the pot position and no discharge hose is installed: This way there is no flow and the pump motor is working but the circuit Is closed. So pressure Is built In the system and motor starts to over -heat and the thermal switch activates to protect the equipment. This only takes a minute or two and will throw the pump. 2. If filtration system is clogged by breading (filtration pan or internal pipes or flex hose). Again, there is no flow in the pipes or flex hose and the pressure increases. The pump motor works harder trying to create a flow, then the motor starts to over -heat. To protect the equipment, the thermal switch activates and shuts down the pump. It may take up to an hour or more for the pump to cool down so that you can reset the pump. Solution: • Depending how hot the motor was, time is required to let cool down the motor. Time to cool down depends of many factors such as temperature of the motor when thermal switch shut down the pump, and how long the fryer was cooking. • After a certain cooling time, reset by pushing with force on the black button located on the back or the left side of the fryer. Note: Pump Reset issue is not covered under warranty. Reset with Bracket Access Direct Access Pump Reset HI -LIMIT THERMOSTAT RESET Explanations: • Hi -Limit thermostat will pop-up most of the time when fryer has been heated -up without enough oil or with no oil in the fryer pot. • If, when cleaning, Hi -limit thermostat bulb has been hit or damaged by not carefully cleaning. Prevention: Always make sure oil is at oil level indicator before starting heat -up process. Solution: 1. When Hi -limit thermostat pops -up, use a pen to reset — Push green button. 2. If HI -limit Is not resetting, allow extra cooling time. a. If not, in rare occasion, the thermostat may have been permanently damaged, and requires replacement. Note: Damaged Hi -limit thermostat issue is not covered under warranty. SB-0014-00 2019-10-01 Page #35