Laserfiche WebLink
• <br /> • <br /> RXK Series Scissor Lift Racks <br /> 13. Anchor Bases & Console <br /> • 1/4 inch (6 mm) is the minimum allowable gap under the base frames. <br /> • 3 inches (76 mm) is the maximum allowable gap under the base frames. <br /> • (Gap greater than 2 inches (51 mm) requires longer anchors than supplied.) <br /> • Jack rail spacing is 37 7/16 inches (951 mm). <br /> • Runways level within 1/16 inch (1 1/2 mm) at alignment height. <br /> • Anchor holes diameter is 1/2-inch. <br /> • After the grout has cured,torque anchors to 50 60 ft-lb. <br /> is NOTE <br /> Using less than 1" (25 mm) gap underneath base frames may result in air jacks interfering with the threshold. <br /> 13.1 . Leveling Runways <br /> Lift is designed such that alignment legs are no longer required. All vehicle alignments can be performed with the runways <br /> resting on any lock position. It is highly recommended that a rotating laser type level be used. Once the rack has been <br /> grouted and secured to the floor, it is impossible to correct errors in the leveling process short of breaking out the grout and <br /> repeating the leveling procedure. Install six 1/213 X 3 inch leveling bolts into the tapped holes in each base frame. <br /> -fir- �'� �►° <br /> o•f �o <br /> LEVELING BOLT <br /> ° LOCATIONS <br /> N TE <br /> For r ei+F►t�sLl• <s in a recessed pit, raise the base such tha -un-ways re-flash with bay floor. <br /> Then raise the rear of t�11 e.base-as-ne unway in the typical bay with the slope toward the garage <br /> door -— <br /> Set the runways onto the locks approximately 30 inches (762 mm) off the ground. This can be accomplished as follows: <br /> Turn the "POWER" switch to the "OFF" Position. Partially open the control console cover so the circuit board is visible. Verify <br /> the jumper across pins labeled "S1" on the circuit board is in place. Depress and hold the button labeled "SW1" on the circuit <br /> board and simultaneously turn the"POWER"switch to the "ON"position. Release the"SW1" button. The green LED located <br /> on the front of the cover should be off and the red LED on the control board should be on (if not,turn the "POWER" switch <br /> "OFF" and repeat this procedure). The control circuit is now in calibration mode <br /> Page 39 of 80 <br />