1200 INDUSTRY ST 2025-03-24 - Laserfiche WebLink

conditions have been corrected. Commencement or continuation of work constitutes acceptance of conditions and responsibility for satisfactory performance. C. Refer to project specifications for additional information. D. All work is to be coordinated with the owner's designated representative and facility manager. E. The contractor is responsible for providing documentation after asbestos abatement is completed, including a general narrative of the asbestos oversight work completed with pictures if applicable; documentation on the licensed personnel that provided the oversight for the work; copies of any oversight sampling needed or required; and copies of final disposal manifests. F. It shall be the responsibility of the contractor to locate all existing utilities whether shown herein or not, and to protect utilities from damage. The contractor shall bear all expenses of repair or replacement of utilities or other property damaged by operations in conjunction with the execution of the work. G. The consultant and owner are not responsible for the acts and omissions of the contractor, subcontractors, or material suppliers including but not limited to the following: safety precautions/ program and their enforcement, construction means and methods, construction techniques, sequencing and procedures employed by the contractor, and subcontractors, the manufacturers' published requirements, procedures, verbal directions documented and undocumented from the manufacturer regarding application techniques or procedures from their staff-issued to the contractor or subcontractors on site. H. It is the responsibility of the contractor to protect building occupants and the public from falling debris or equipment. Do not throw materials from the roof. Contractor is responsible for protecting building surfaces, finishes, and systems from damage, discoloration, etc. during all construction activities. I. Contractor is responsible for verifying all dimensions and conditions of the project, including verification of existing roof system construction and materials. J. Contractor staging and storage areas shall be as directed by the owner's representative at the pre-construction meeting. Contractor shall assume a reasonable amount of storage and staging space will be made available. K. Contractor is responsible for knowing the roof deck loading capacity of the existing building for storage of materials on the existing structure. Do not overload the roof structure with materials, equipment, or debris. L. Personal fall protection devices are not, nor will be, provided by the owner on any roof area designated to receive work. Personal fall protection is the responsibility of the contractor. M. Existing materials and construction are noted on the drawings as existing. All other notations indicate new materials, products, and construction unless otherwise stated or indicated. N. All hazardous materials, including, but not limited to asbestos, lead and PCB containing materials must be removed by a qualified and licensed abatement contractor in accordance with the local, state, and federal authorities having jurisdiction. Contractor is to provide all documentation required by the local authorities including material manifests for disposal and air monitoring reports were required. O. The new roof system will incorporate low-no-odor adhesives in the application in accordance with current OSHA regulations. P. Add new wood nailers, as required, to match depth of the new insulation. Q. Add additional wood blocking and plywood to parapet walls as designed in contract drawings. Raise gravel stop edges to exceed insulation height by (1) 2 x board at the lowest point unless the edge is associated with a gutter drainage system or contract drawings provide an alternate design. R. New wood nailers must be a set 1/4" below the finished roof surface at all gutter edges and primary scupper escutcheons. SEA00511 / Prologis - SEA00511 01 1000 -4 Summary - FY24- Everett 1 - Capital Roofing Project