2930 MAPLE ST KAISER PERMANENTE 2025-05-12

KAISER PERMANENTE Site Prep #1 Electrical Service ASC & Clinic (HUB) March 18, 2020 Everett, WA Project No. 19.05002.00 4. Requirements of OSHA, EPA and WISHA. 5. National Fire Protection Association Codes. 6. ASME codes for boiler and pressure vessels. 7. SMACNA HVAC Duct Construction Standards, latest edition. 8. All local and state amendments. 9. Requirements of all agencies have jurisdictional authority over installation of mechanical systems. C. Permits, Fees and Inspections: 1. Contractor shall arrange and pay for all permits, fees and inspections required in connection with this installation. The Contractor shall present the Owner with properly signed certificates of final inspection before the work will be accepted. 2. Contractor shall call for all inspections by local building official(s) when they become due, and shall not cover any work until approved by these governing authorities. 3. Contractor shall make all arrangements with utility companies for water, steam, gas and drainage services, etc., associated with the work and include required payments for meters, piping, services, connection charges and materials furnished and installed by utility companies. Work and materials shall be in strict accordance with rules of respective authorities. D. Underwriters Laboratory Approval: Where Underwriters Laboratories (UL) standards exist, all items of electrical equipment or items partially composed of electrical equipment shall carry Underwriters Laboratories (UL) label either for the entire unit or for the electrical portion of the equipment. If UL standards do not exist, equipment shall be provided that has been labeled by an independent testing agency that is recognized by the authority having jurisdiction. E. ASME Code Stamp: ASME code stamp required on all pressure vessels and relief valves. Certificate required from the Boiler Inspector showing approval of the equipment and its installation. 1.6 WORK INCLUDED A. Work under this division shall include providing all materials, labor, equipment, tools, appliances, hoisting, scaffolding, supervision and overhead for the proper execution and completion of the mechanical work. B. Should these specifications or references made therein fail to specify adequately an item of equipment or material required for proper completion of the work in accordance with present day practice, this deficiency shall not relieve Contractor from furnishing and installing same. Call such omissions to attention of Architect and use such equipment or material as approved by Architect. C. All new equipment and products as noted in Part 2 of each section shall be installed as per manufacturer's recommendations. 1.7 WORKMANSHIP A. This Contractor shall provide completed systems with a neat and finished appearance. If, in the judgment of the Architect, any portion of the work has not been performed in a workmanlike manner or is left in a rough, unfinished state, this Contractor will be required to remove, reinstall or replace same and patch and paint surrounding surfaces in a manner acceptable to the Architect, without increase in cost to the Owner. COMMON MECHANICAL MATERIALS AND METHODS 23 05 00 - 4