210 SW EVERETT MALL WAY LITTLE PANDAS PLAY CAFE 2025-04-14

Lighting, Motor and Electrical Requirements List, pg 2 of 13 2021 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1-- Administered by©2024 NEEA,All rights reserved The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the Washington State Energy Code,Commercial Provisions. For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com NA Indicate occupant sensors are configured to automatically reduce lighting power by>_50% when the zone is unoccupied for over 20 minutes;indicate controls are configured to automatically restore lighting to full power when the zone or space is occupie NA C405.2.1.2 Occupant sensor Indicate method of automatic 100%shut-off controls-warehouse (occupancy sensor or time switch) storage areas& library stacks NA C405.2.1.3 Occupant sensor For open plan office areas larger than 300 sf, controls-open plan indicate all general lighting control zones are office areas <600 sf NA C405.2.1.3 Occupant sensor Indicate all general lighting control zones are controls-open plan provided with vacancy controls that are office areas configured to reduce lighting power by not less than 80%when the zone is unoccupied I j and turn luminaires 100%off when the control zone is unoccupied;indicate unoccup NA C405.2.1.4 Occupant sensor Indicate stairway lighting is provided with controls-enclosed occupancy sensor controls that reduce lighting fire-rated stairwells power by not less than 50%when the stairway in unoccupied and restore lighting to 100% when it is occupied. NA C405.2.1.5 Occupant sensor Indicate corridor lighting is provided with controls-corridors occupancy sensor controls that reduce lighting power by not less than 50%when the corridor is unoccupied. NA C405.2.2.1 Automatic time i Indicate spaces on plans where time switch switch controls controls are configured to turn luminaires 100%off during unoccupied hours NO Indicate spaces on plans where time switch controls are configured to turn on lighting to full power versus 50%power NA Indicate locations of override switches on plans and the lighting zone(s)served;indicate that the area(s)served by each override switch does not exceed 5,000 sf. NA C405.2.5.2 Daylight zones- Indicate primary and secondary sidelit C405.2.5.4 Sidelit zones daylight zone floor areas on plans NA For small vertical fenestration assemblies (rough opening less than 10%of primary daylight zone floor area)where daylight responsive controls are not required,provide fenestration area to daylight zone floor area calculation(s). NA Indicate toplit daylight zone floor areas on plans. NA C405.2.5 Daylight responsive Indicate on plans all lighting zone(s)served by C405.2.5.1 controls daylight responsive controls;indicate that the area served by each control device does not exceed 2,500 SF Page-2/43 5I1