Laserfiche WebLink
Lighting, Motor and Electrical Requirements List, pg 4 of 13 <br /> • <br /> 2021 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1-- Administered by©2024 NEEA,All rights reserved <br /> The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the <br /> Washington State Energy Code,Commercial Provisions. <br /> For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br /> NA C405.2.6, Lighting for non- For lighting serving non-visual applications <br /> Item 3 ' visual applications (food warming and lighting for life support of <br /> nonhuman life forms),indicate on plans that <br /> lighting fixtures are controlled independently <br /> from both general area lighting and other <br /> lighting applications within <br /> NO Indicate on plans separate manual controls for <br /> non-visual lighting application fixtures and <br /> applicable automatic lighting controls; <br /> indicate that the area served by each control <br /> device does not exceed 4,000 sf. <br /> NA For task lighting that serves medical&dental <br /> purposes,indicate on plans that lighting <br /> fixtures are provided with manual control that <br /> is independent from general area lighting. <br /> NA C405.2.6, Means of egress Identify all means of egress lighting fixtures <br /> Item 5 lighting on plans including fixtures that function as <br /> both normal and emergency illumination <br /> NA ! Provide calculation for total lighting power <br /> density(LPD)of all means of egress lighting <br /> fixtures;if total LPD is>_0.01 Watts/SF, <br /> indicate on plans the method of automatic <br /> shut-off control during unoccupied periods <br /> (emergency relay&occupancy sens <br /> NA C405.2.8 Advanced lighting For open office areas>5,000 sf,indicate <br /> controls in open I which advanced lighting control system is <br /> office areas provided(luminaire level lighting controls or <br /> networked lighting controls). <br /> C405.2.8.1 Luminaire level Where LLLC are provided to comply with <br /> lighting controls C4(15.2.8.or provided as the alternate lighting <br /> (LLLC) controls compliance method per C405.2.or to <br /> comply with C400.2.4.2 Enhanced digital <br /> interior lighting controls:provide sequence of <br /> operations that describes required <br /> NA C405.2.8.1 Luminaire level ' Indicate on plans that each LLLC luminaire is <br /> C405.2.8.3 lighting controls configured with occupancy sensing control <br /> (LLLC) functions(including C405.2.1.3 requirements <br /> for open office areas)and continuous full <br /> range dimming controls to brighten or dim <br /> lights based on occupancy and availab <br /> NA C405.2.8.2 Networked lighting Where NLC are provided to comply with <br /> control(NLC) C405.2.8,or to comply with C406.2.4.2 <br /> Enhanced digital interior lighting controls; <br /> provide sequence of operations that describes <br /> required NLC capabilities and performance <br /> parameters <br /> NA C405.2.8.2 Networked lighting Indicate on plans that each NLC luminaire is <br /> C405.2.8.3 control(NLC) individually addressable or document <br /> exception applied;Indicate on plans that each <br /> NLC luminaire is configured with occupancy <br /> sensing control functions(including <br /> C405.2.1.3 requirements for open office <br /> areas) <br /> Page-4 1 I1 <br />