Laserfiche WebLink
CITY OF EVERETT SPECIAL PROVISIONS <br />LS47-Beverly Lake Sewer Replacement Division 1 – GENERAL REQUIREMENTS January 30, 2025 <br />WO No – UP3529 SP – 117 <br />the record drawings prior to Final Acceptance. Final Acceptance will not be issued until <br />the City accepts the record drawings. <br />1-08.11(2) Recording Changes <br />As a minimum, record the following items on the record drawings: <br />a. Actual dimensions, arrangement and materials used when different than <br />shown on the Plans. <br />b. Changes made by Change Order or Field Order. <br />c. Changes made by the Contractor. <br />d. Horizontal and vertical locations of underground utilities and appurtenances, <br />shall be referenced to monumentation. The monumentation shall be based <br />on NAD 83-91 for Horizontal Datum and NAVD 88 for Vertical Datum. <br />e. Any changes in centerline profile and curb & gutter (top of curb), offsets and <br />elevations. <br />f. Details, Equipment or materials used that were not shown on the original <br />Plans. <br />g. The actual arrangement and routing of conduit, embedded conduit, raceways <br />and piping relative to its location and proportioned to other work. The location <br />needs to be dimensioned on the record drawings. <br />h. Contractor prepared piping schematics and diagram drawings representing <br />the Equipment orientation. <br />i. Final location of all surface and subsurface improvements. <br />j. Record on the drawings the location of all field run materials. <br />k. All shoring systems left in place at the end of construction. <br />Contractor shall accurately show existing underground items including, but not limited <br />to, piping, manholes, pull boxes, conduit, direct buried wire, foundations, equipment and <br />obstructions found during construction on the record drawings. Note on the record <br />drawings the actual size of all utilities and structures and types of material used. Locate <br />all record drawing items by survey coordinates or dimensioned off NAD 83-91 for <br />Horizontal Datum and NAVD 88 for Vertical Datum. Minimum requirements for accuracy <br />are specified in the following chart. <br /> <br /> Description Horizontal <br />Location <br />Elevation Notes <br /> Gravity sewer and <br />drain lines <br />Coordinates, <br />stations, and <br />offsets 0.1 ft. <br />I.E. 0.01 ft. Recalculate actual slopes. <br />All inverts in manholes. <br />All angle changes. <br /> Forcemains, <br />watermains and <br />transmission lines <br />Coordinates <br />and stations 0.1 <br />ft. <br />I.E. 0.1 ft. Record all angle points and <br />finished ground elev. Above <br />the invert elev. <br /> All other items, incl. <br />Electrical and <br />Structural <br />0.1 ft. 0.1 ft. Show dimensions on record <br />drawings. <br />Use red pen within Autodesk BUILD markup tool to make changes on the record <br />drawings. Notations are to be neat, legible, clear and concise. <br />Record information concurrently with the progress of construction. Conceal no work <br />until the required information is verified and recorded.