Laserfiche WebLink
The comments below were generated from this project's City of Everett Traffic Engineering Reviewer. All questions shall be routed through this project's <br />Public Works Reviewer Thad Newport with City of Everett Permit Services (TNewport(cDeverettwa.gov). <br /># <br />Document <br />Sht/Pg <br />Reviewer's Comment <br />Designer's Response <br />Initials <br />3. Please either call out on this sheet in detail 2 or note the <br />location of the COE foundation finishing details located on detail <br />5 of sheet G1 including but not limited to the %" chamber, no <br />chamber in paved area callout, the 2" nominal grout pad callout, <br />4. conflicts have been removed <br />and the 1" min — max in unpaved area... callout. <br />4. Please remove the conflicting foundation information <br />between this sheet and detail 5 of G1 following the necessary <br />manufacturer foundation information where required and using <br />the COE foundation information wherever possible. <br />7 <br />RF-3 <br />1. The recommendation from page 10 of the Radio Frequency <br />Callout has been revised to state 3' <br />Emissions Compliance Report states that notice is required 3' <br />below the antenna, however the callouts on this sheet say signs <br />must be placed 2' below the antenna. Please clarify which <br />distance is to be used. <br />8 <br />Valmont <br />1. Please make the information shown on the A series sheets <br />TelCyte to address conflicting information <br />shop <br />corroborate with the pole shop drawings, and the work being <br />drawing <br />done on the IL and TS sheets. Comments 2-7 explicitly deal with <br />making sure no conflicting information is being shown in <br />different sheet series. <br />2. The existing pole has a 30' luminaire mounting height as <br />2. Complete Valmont poles drawings provided. <br />shown in the A series sheets, however the Valmont pole shop <br />This site will specifically use Pole Item #9, 10' <br />drawing is calling for a luminaire mounting height of 35'. Please <br />luminaire arm with a 30' fixture mounting <br />submit complete Valmont pole and luminaire arm shop drawings <br />height. <br />for a pole with 30' luminaire mounting height. <br />3. There is cabinet enclosure information (festoon box) shown in <br />the A series sheets A3 and A4 as well on sheet RF2 that are not <br />3-4. The cabinet enclosure is not being provided <br />shown in the Valmont pole and luminaire arm shop drawings and <br />by Valmont thus it would not be shown in their <br />a note on this sheet asking for festoon box information if it is <br />submittal package. The loading is accounted for <br />required. Please submit complete Valmont pole shop drawing <br />in the calculations and loading information was <br />that show the enclosure information shown on these sheets. <br />added to the pole drawing package. <br />4. There is a cabinet enclosure mounted at 16' shown on sheets <br />A3 and A4. There is a semi -flush handhole shown on the Valmont <br />Page 7 of 10 <br />