Laserfiche WebLink
ODTOLCO" <br /> Revision00: <br /> Fig. 4L C&11 L151E1 <br /> Longitudinal "In-Line" Sway Brace Attachment FM <br /> Size Range — 2" through 8" IPS. <br /> Material — Carbon Steel <br /> Function — For bracing pipe against sway and seismic disturbance. / <br /> Approvals — Underwriter's Laboratories Listed in the USA(UL) and <br /> Canada (cUL) 2" - 8". Approved by Factory Mutual Engineering (FM), <br /> 2" - 8" pipe. <br /> Installation Instructions — The Fig. 4L is the "braced pipe" attachment <br /> component of a longitudinal sway brace assembly. It is intended to be D A <br /> combined with the "bracing pipe" and TOLCO structural attachment <br /> component to form a complete bracing assembly. NFPA 13 and/or <br /> OSHPD guidelines should be followed. <br /> To Install — Place the Fig. 4L over the pipe to be braced and tighten <br /> bolts. Then engage "bracing pipe" into jaw opening and tighten set bolt <br /> until hex head snaps off. Jaw attachment can pivot for adjustment to G <br /> proper brace angle. <br /> Finish — Plain <br /> Note — Available in Electro-Galvanized and HDG finish. <br /> Order By — Figure number, pipe size and finish. <br /> o ° Dimensions •Weights <br /> �..� Max. Rec. *Max Rec. <br /> Sizes A C D B olt Load Lbs. Load Lbs. Approx. <br /> I ; Size (cULus) (FM) Wt./100 <br /> 21/2 67/16 21/2 23/4 1/2 2015 3000 253 <br /> 3 7 23/4 31/16 1/2 2015 1550 268 <br /> 4 81/2 33/8 311/16 1/2 2015 1550 348 <br /> O 5 93/4 37/8 43/8 112 2015 1450 380 <br /> Longitudinal Brace 6 111/2 5 51/8 1/2 2015 1450 640 <br /> 8 131/4 611/16 61/8 1/2 2015 1450 728 <br /> Load shown is allowable with brace installed,between 30°-90°.No reduction of load <br /> b <br /> based on brace angle is required. <br /> FM approved when used with 1",11/4", 11/2"or 2"Sch.40 brace pipe. <br /> 4-Way Riser Brace <br /> (Plan view) <br /> TOLCO°brand bracing components are designed to be compatible ONLY with other TOLCO°brand bracing components, resulting in a Listed seismic <br /> bracing assembly. DISCLAIMER — NIBCO does NOT warrant against the failure of TOLCO®brand bracing components, in the instance that such <br /> TOLCO®brand bracing components are used in combination with products, parts or systems which are not manufactured or sold under <br /> the TOLCO®brand. NIBCO shall NOT be liable under any circumstance for any direct or indirect,incidental or consequential damages of any kind, <br /> including but not limited to loss of business or profit,where non-TOLCO brand bracing components have been,or are used. <br /> OFFICE/MANUFACTURING FACILITY•1375 SAMPSON AVE.•CORONA,CA 92879•PH: 951.737.5599•FAX: 951.737.0330 m <br /> CUSTOMER SERVICE•800.786.5266 <br /> www,tolco.com <br />