Laserfiche WebLink
RevisionIDTOLCO" www.tolco.com <br /> a brand of NIBCCY 00: <br /> Fig. 1001 - Sway Brace Attachment Component of State of C �L US LISTED <br /> California OSHPD Approved <br /> Size Range — Pipe size to be braced: 21/2" thru 8" IPS.* Pipe size Seismic Restraints System Mo <br /> used for bracing: 1" and 11/4" Schedule 40 IPS. <br /> Material — Carbon Steel <br /> Function — For bracing pipe against sway and seismic distur- <br /> bance. The pipe attachment component of a sway brace system: <br /> The Fig. 1001 is used in conjunction with a TOLCO 900 Series fitting <br /> and joined together with bracing pipe per NFPA 13, forming a com- <br /> plete sway brace assembly. <br /> Features — Can be used to brace schedules 7 through 40 IPS. <br /> Field adjustable, making critical pre-engineering of bracing pipe <br /> length unnecessary. Unique design requires no threading of brac- <br /> ing pipe. Can be used as a component of a four-way riser brace. <br /> Comes assembled and ready for installation. Fig. 1001 has built-in <br /> visual verification of correct installation. See installation note below. <br /> Installation Note — Position Fig. 1001 over the pipe to be braced <br /> and tighten two hex head cone point set bolts until heads bottom <br /> out. A minimum of 1" pipe extension is recommended. Brace pipe <br /> can be installed on top or bottom of pipe to be braced. <br /> Approvals — Underwriters Laboratories Listed in the USA(UL) Maximum Design Load <br /> and Canada (WL). Approved by Factory Mutual Engineering (FM). Sch. 7 - 1600 lbs. <br /> Sch. 10 & 40 <br /> Included in our Seismic Restraints Catalog approved by the State 1" Brace Pipe - 2015 lbs. <br /> of California Office of Statewide Health Planning and Development Sch. 10 &40 w/1 /a Brace Pipe - 2765 lbs. <br /> (OSHPD). For additional load, spacing and placement information <br /> relating to OSHPD projects, please refer to the TOLCO Seismic FM Approved Design Loads* <br /> Restraint Systems Guidelines. 21/2" - 2400 lbs. <br /> Finish — Plain 3" - 4" - 2500 lbs. <br /> Note — Available in Electro-Galvanized and HDG finish. <br /> 5" - 8" - 1500 lbs. <br /> Order By — Indicate pipe size to be braced followed by pipe size <br /> used for bracing, figure number and finish. <br /> Important Note — The Fig. 1001 is precision manufactured to <br /> perform its function as a critical component of a complete brac- <br /> ing assembly. To ensure performance,the UL Listing requires <br /> that the Fig. 1001 must be used only with other TOLCO bracing <br /> products. The Fig 1001 is not intended for use with the Fig. 907 <br /> 4-Way Longitudinal Brace Attachment. <br /> OFFICE/MANUFACTURING FACILITY•1375 SAMPSON AVF.•CORONA,CA 92879•PH: 951.737.5599•FAX: 951.737.0330 <br /> CUSTOMER SERVICE•800.786.5266 <br /> www.tolco.com <br />