Faber Construction Corp 9/27/2016

CITY OF EVERETT SPECIAL PROVISIONS 5-04.3(8)A1 General ' Delete all five paragraphs in 5-04.3(3)A1 and substitute the following: Acceptance of HMA shall be as defined under nonstatistical or commercial evaluation. Nonstatistical evaluation will be used for all HMA not designated as Commercial HMA in the contract documents. The mix design will be the initial JMF for the class of HMA. The Contractor may request a change in the JMF. Any adjustments to the JMF will require the approval of the Project Engineer and must be made in accordance with Section 9-03.8(7). Commercial evaluation may be used for Commercial HMA and for other classes of HMA in the following applications: sidewalks, road approaches, ditches, slopes, paths, trails, gores, prelevel, and pavement repair. Other nonstructural applications of HMA accepted by commercial evaluation shall be as approved by the Project Engineer. Sampling and testing of HMA accepted by commercial evaluation will be at the option of the Project Engineer. Commercial HMA can be accepted by a contractor certificate of compliance letter stating the material meets the HMA requirements defined in the contract 5-04.3(8)A4 Definition of Sampling Lot and Sublot Supplement 5-04.3(8)A4 with the following: For HMA in a structural application, sampling and testing for total project quantities less than 400 tons is at the discretion of the City Inspector. For HMA used in a structural application and with a total project quantity less than 800 tons but more than 400 tons, a minimum of one acceptance test shall be performed: 1. If test results are found to be within specification requirements, additional testing will be at the City Inspector's discretion. 2. If test results are found not to be within specification requirements, additional testing as needed to determine a CPF shall be performed. 5-04.3(8)A5 Test Results Delete the first paragraph of 5.04.3(8)A5. 5-04.3(8)A6 Test Methods Delete the paragraph in 5-04.3(8)A6 and substitute the following; Testing of HMA for compliance of Va will be at the option of the City. If tested, compliance of Va will be use WSDOT Standard Operating Procedure SOP 731. Testing for compliance of asphalt binder content will be by WSDOT FOP for AASHTO T 308. Testing for compliance of gradation will be by WAQTC FOP for AASHTO T 27/T 11. 5-04.4 Measurement Delete all paragraphs of 5-04.4 and substitute the following: I Bid items of Work completed pursuant to the Contract Documents will be measured as described in Division B — Bid Item Descriptions of these Special Provisions and Section 1-09 MEASUREMENT AND PAYMENT of the Standard Specifications. I Water Main Replacement Q Division 5—SURFACE TREATMENTS July 8, 2016 -Broadway AND PAVEMENTS WO No.—UP3612 SP -142