Faber Construction Corp 9/27/2016

CITY OF EVERETT SPECIAL PROVISIONS , Bid items of Work completed pursuant to the Contract Documents will be measured as described in Division B — Bid Item Descriptions of these Special Provisions and Section 1-09 MEASUREMENT AND PAYMENT of the Standard Specifications. 8-01.5 Payment Delete all paragraphs in 8-01.5 and substitute the following: Payment for bid items of Work completed pursuant to the Contract Documents will be as described in Division B — Bid Item Descriptions of these Special Provisions and Section 1-09 MEASUREMENT AND PAYMENT of the Standard Specifications. 8-02 ROADSIDE RESTORATION 8-02.3 Construction Requirements , 8-02.3(16) Lawn Installation 8-02.3(16)A Lawn Installation Delete 8-02.3(16)A and substitute the following: 8-02.3(16)A Lawn Installation — Sod Install sod in irrigated areas only after the irrigation system is fully operational. Unless the Engineer approves otherwise, install sod between March 1 and October 1. Place sod strips within 48-hours of being cut. Place strips without voids and stagger the end joints. Roll sod with a smooth roller following placement to ensure good contact with the soil. During the establishment period, erect barriers, with warning signs where necessary, to preclude pedestrian traffic over the newly placed sod. Prepare areas for sod in accordance with standard horticultural practices as follows: 1. Rototill, or otherwise cultivate, to a minimum depth of 4-inches into the ground surface. Thoroughly incorporate a 10-2-10 fertilizer in the rototilling process at a rate of 4 pounds of available Nitrogen per 1000 square feet. 2. Rake the surface to even grade without low spots to trap water and round surface to match surroundings. 3. Add topsoil as required by the design. NOTE: Topsoil will be paid for separately if required. 4. Lightly dampen and compact the finished grade. 5. Install sod taking care to butt each piece tightly against the adjacent one. Stagger butt joints. Lay sod on sloped areas with the long dimension parallel to the toe or top of slope. After placing, roll the sod and sprinkle heavily with water. 6. Provide tools specially designed for the work and satisfactory to the Engineer. 7. Water and fertilize the sod during the 90 days establishment period. Schedule watering to prevent joints from drying between sod strips. Apply 6-2-4 fertilizer at 6 week intervals at the rate of 1 to 1-1/2 pounds of available Nitrogen per 1,000 square feet per application. Where Shown that sod is to be replaced, the work shall consist of the removal and replacement of existing lawn turf by cutting the sod to be removed into convenient sized squares or strips to uniform thickness, piling and storing in a dampened condition, and finally replacing the sod in its original position. This work will be performed where the special provisions provide for such work. Water Main Replacement"Q" Division 8—MISC CONSTRUCTION July 8, 2016 -Broadway WO No.—UP3612 SP -164