7125 EVERGREEN WAY 2018-01-02 MF Import

contair,er or drum and sent to a scrap r�etal recvcler or hazardous waste manaeement faciliry and shali not be placed in a dumpster without first checking with Snohomish County Health Department. Undmined filters shall not be placed in the dumpster under any circumstances. Gas, oil, transmission, and hvdraulic fluids, radiator coolant and any other fluids shall be drained from vehicles being scrapped or retired vehicles which will be kep[ on site. These fluids shall be disposed of properly, preferably by recycling. �i-21.3 B�IP S1.20 VEHICLE/EQLTP�IENT W:�SHPiG A_V� STE��I CLE�+„�1Ir'G Washins of vehicles, equipment and parts such as construction equipment, shall occur in a buiiding or in a desimtated area such az that desc: ibed below. This requirement refers to alt methods of washin� in which water is used, includins low-pressure water, high-pressure water, and steam. 1Vote: The ure of mobrle wash services is not allowed unless the wash water can be contained cmd discharged to a sanrtarv setiver per the req:�irements of the Ciry's Industrial Pre.rearment Program or discharged into and be treated by a closed-loop recycling svstenr. EYceptrons to these General Requirements are noted below. GEN'ERAL REQUIREMENTS Wash water from vehicle and equipment cleanins shall be discharoed to the sanitazy sewer, afrer meeting the requirements of the City's Industrial Pretreatrnent Program. The owner shall conduct washins in one of the __ followin� locations in order of oreference: - 1. At a commercial washin� business in which the washin2 occurs in sn enclosure and drains to the sanitarv sewer or; ` _ 2. Inside the owner's vehicle or equipment building which is plumbed to drain to the sanitary sewer or; 3. In a buildine the owner has constructed specifically for washing of vehicles and equipment which is plumbed to drain to the sanitary sewer or; 4. In a covered, outside area desienated by the vehicle owner as a H�ash area, meetin� the requiremenu outlined below. REQUIREI�IENTS FOR WASH AREAS 1. The area shall be paved, preferably with Portlai,� cement, and constructed as a spill containment pad to prevent the run-on of stormwater from adjacent pavement areas ihe wash area shall be sraded so that all water is collected in a drain system. The drain system may consist of perimeter drains, trench drains, or ca:chment drains. The wash pad shall be sized to extend out a minimum of four feet on all sides of the vehicles and/or equipment bein� wazhed. ?. A Portland cement spill containment pad is required for steam cleanino. 3. .411 wash water shall discharse to the sanitary sewer, process treatment, or a dead-end sump, per Industrial Pre[reatment Proeram requirements. 4. In areas where the wash wata,- cannot be dischazsed to a sanifary se�ver, wash �vater must be collecced in a dead-end sump, tank, or ether device and transported to the nearest sanitary facility for proper disposal. �. The wash area shall be well marked at =as stations, multi-family residencee, and any other business where vehicles may be washed by noa-employzes. Included in the postin� shall be a statement forbiddin� the changine oI oil in the wash area.