4522 EVERGREEN WAY 2018-01-02 MF Import

PUBLIC Is November 2, 2011 Mr. Michael Smith, P.E., S.E. Pacific Engineering Technologies, Inc. 1700 Westlake Avenue N., Suite 100 Seattle, WA 98109 Project: Retail Addition and Fire Damage Repair Job Address: 4522 Evergreen Way Plan Review No: B1109-026 Sent via a-mailLLL�'.l - Dear Mr. Smith, In response to the application for building construction permit, the plans have been examined and you are advised that a permit cannot be issued until the following issues are resolved. Please submit two sets of revised plans and details with a response letter, which indicates where each item in this corrections letter is addressed on the plan set. G neral comments 71. The building data table should make z inction between area of repair and area of new construction. The replacement of the u , nolished storage area is being reviewed as new construction. 2. The site plan should identify the scope of all new construction/demolition to the paving and grading, to include the accessible route to the main door, new parking space striping, and the removal of existing parking spaces on Evergreen Way. 3. Please submit a roof plan with target references to details for the existing building and new addition, and identify the extent and type of insulation (existing or new). Occupancy 1 1. Occupancy classifications and occupant load calculations should be submitted for the retail and storage areas, per IBC table 1004.1.1. 2. If the space is business use, not retail, the occupant load calculations and plans should identify the specific uses, per IBC section 508.1. 3. The code analysis should identify if the occupancy uses are accessory, non -separated or separated, or some combination, per IBC sections 508.2, 508.3 or 508.4. Egress ✓1. Two exits are required when the occupant load calculations exceed 49 people, per IBC Table 1021.2. Construction Primary and secondary roof drainage should be shown on the drawings, per UPC sections 1101.11.1 and 1101.11.2. Gutters are required on the roof of the new addition, and should be shown on the drawings, per UPC 1101.11.1.