10721 EVERGREEN WAY ARA COLLISION 2016-01-01 MF Import

. � . • � � NP 6. Identify if the repair of vehicles fueled by nonodorized gases will occur in this facility, for which a gas detection system should be provided per Section 406.6.6. ��';Ta�� 0 7. The storage in the ceilings above the accessory B occupancy should be posted for 40 psf maximum allowable loads, based on the structural calculations submitted, per Section 3403.2.2. The access to the storage areas should be shown on the plans. v 8. The new paired south cntrance doors should swing in the direction of egress, and the door material should be identified, per Section 1008.1.2. ✓ 9. The glazing identified in the observation room requires a section or description of the size and location of the fixed panel to determine if safety glazing is required per Section 2406.3. � 10. In the new toilet room, floor should be shown to continue up walis a minimum of 6 inches per Section 1210.2. . Accessibility Issues per ICC/ANSI A117.1-2003 1. Water closet: the centerline oi the fixture should be 16 inches minimum and 1 S inches maximum from the side wall-Section 604.2. 2. Water closet: height should be 17 inches minimum and 19 inches maximum above the floor, measured to the top of the seat-Section 604.4. 3. Water closet: clearance should be 60 inches minimum, measured perpendicular from the sidcwall, and 56 inches minimum, measured perpendicular from the rear wall-Section 6043.1. No other fixtures or obstructions shall be within the reauired water closet clearance-Section 604.3.2. 4. Grab bars: horizontal sidewall bar minimum 42 inches long, 12 inches maximum from rear wall, extending 54 inches minimum from rear wall-Section 604.5.1. 5. Grab bars: vertical sidewall bar minimum 18 inches long, mounted with bottom of bar located between 39 and 41 inches above the floor, and center line of the bar located between 39 and 41 inr,hes from rear wall-Section 604.5.1. G. Grab bars: Rear wall grab bar minimum 36" long, extending 12" minimum from the centerline of the water closet to the side closest to the wall, and 24 inches minimum on the transferside- Section 604.5.2. 7. Sink: The front of the sink should be 34 inches maximum above the floor, measured to the higher of the rim or counter surface- Section 6063. Knee clearance should be 11 inches minimum in depth at 9 inches above the floor, and 8 inches minimum in depth at 27 inches above the floor, with a clearance reduction allowed per Section 396.3.4. 8. Sink: Exposed pipes and surfaces should be insulated or configured to protect against contact-Section 606.6. � iweoi.ou m�zi t;��R�;�w,r.m� //) `I' '