2131 LAKE HEIGHTS DR 2016-01-01 MF Import

If the Coneractor chooscs �o usc the Qualified Products List (QPL) the Contractor shall use the mos[current list available at the time the Contractor proposes[o use or install the product. IThe QPL identifies the approved products, Ihe applicable specificalion section, and the basis for acceptance at the project level. The listing is divided into two categeries, "Approved" and "Conditionally Approved". I "Approved"��roducts are denoted with an "A". These products may be accepted without s.dditional sampling or documentaticri. "Conditionally Approved" products are denoted with a "CA". The acceptance and use of these products is based upon additional job sampling and/or documentation. AIl additional acceptance Iaciions need to be completed prior to the material being incorporated into the project. � Those products listed on the QPL will not require advanced Approval of Source by the Enginecr. The � I Contractor shal! advise the Engineer of the intended items for use from the QPL by reference to the contract bid item. Items not included on the QPL shall be submitted for approval, using the normal source approval j process, Requesf for Approval of Material Source,(DOT Form 350-071). � IThc use of listea products shall be restricted to the Standard Specification for which they are listed and fulfillment of the acceptance requirement defined in the QPL. Qualified products nc,t confortning to the I specifications, not fulfilling the acceptance requirements, or improperly handled o� installed, shall be replaced at the Contractor's expense. 1 I To qualify for conrinued listing on the QPL, products may be sampled and tested for confortnance to the Standard Specifications. The Contracting Agency reserves thc right to make revisions to the QPL at any � time. If there is a conflict between the QPL and the contract, the provisions of the contract shall take precedence j over the QPL. � ISECTION 1-07 LEGAL RELATIONS ANll RESPONSIBILITI�:'o TO THE PUBLl(: I SECTION 1-07.2 OF THE STANDARD SPECIFICATIONS IS SUPP.�EMENTED WITH'ICHE I �OLLOWING: � 1.07.2 Statc Txxes I The work on this contract is to be perfortned upon lands whosc ownership obligates the Contractor to pay Sales tax. The provisions of Section 1-07.2(1)apply. � SECTION 1-07.6 OF THE STANDARD SPECIFICAT[ONS IS SUPPLFMENTED WITH'1fHE I FOLLOWLNG: i 1-07.6 Pcrmits And Licensss If No hydraulic p�rtnits are required for this project unless the Contractors operations use, divert, obstruct, or changc the natural flow or bed of any river or strcam, or utilize any uf the waters of the State or materials Ifrom gravel or sand ba�•s,or from stream beds. I Ip Wc��00NVtV00_��kantptw.doc Davld Evans and Associates,Ina SP-3 71h Ava SPJIOOIh St.Signel Modification IJunc1998