1130 RAINIER AVE A 2018-01-01 MF Import

purposes of egress within lhe gated community. The posted occupancy sign should be for the highest load anticipated for either an assembly use (if less than 49) or an assembly occupancy (if greater than 49), per IBC table 1004.1.1. Egress 1. An architeclural site plan is required for review, for compliance with the building and fire codes, per IBC 1101.2, and IFC Chapter 5. a. Please indicate Fire Department access roads, and Fire Department access to the buildings, inciuding "knox-box" locations near building doors, where applicable. b. Please indicate fire hydrants, post-indicator valves, and similar equipment. c. Please indicate all the improvements for accessible design and the accessible route, in their entirety on the architectural site plan drawings, specifically within the property lines. d. Please identify on the architecturel site plan if this is a 9ated community for vehicular access. e. If the exit discharge is loc,3ted uvhere access to a public way cannol be provided, a safe dispersal area shou�d be shown on the drawings, per IBC section 1027.6. f. If the means of egress is khrough the pedestrian gates shown on the enclosure for the complex, those gates are part of the means of egress and should comply with all requirements listed in Egress item 2 on this letter. All assembly areas (interior and designated exterior assembly areas), sl�ould have the following indicated on the drav�ings: a. Illuminaled exit signs should be shown on the drawings inside the building to two separate exits, per IBC sections 1011.1 and 1014.1. b. Emergency 1i�.3hting should be shown on tl�e reflected ceiling plan inside the building, per IBC sections 1006.1 and 1006.3. c. Gates serving the means of egress for the exterior assembly areas should be shown on [he drawings to conform to the same code requirements for doors, per IBC section 1008.2 d. Where changes of elevation of less than 12 inches exist in lhe means of egress, sloped surfaces should be shown on the drawings, per IBC section 1003.5. e. Tactile exit signs should be shown on the drawings adjacent to each door to the exit discharge, per IBC section 1011.3. f. If locks and latches are provided on doors or gates in assembly areas, signage per IBC section 1008.1.9.3 should be sho�vn on the dia�vings fur each of these areas. 3. Landings are required on both sides of c9ress doors or yafes, per IBC sections 1008.1.5 and 1008.1.6. Doors seroing an assembly occupancy of greater than 50 occupants should not have a latch or lock unless it is panic hardware or fire exit hard�vare, per IE3C section 1008.1.10. Construction 1. Please identify if the hvo buildings are subrnittea in tlie code analysis as portions of one building or as separale buildings, per IBC section 503.1.2. If the buildings are submitted as separate buildings on the same lot, please darify the following on the drawings: