1130 RAINIER AVE A 2018-01-01 MF Import

� � a. An assumed property line for building separation, referenced in tlie cocle analysis, should be shown on tl�e architectural site plan, per IBC section 705.3. b. Area of openings, based on fire separation dis:ance and degree of opening protection, per IBC table 705.8, should be show� on the elevations, where the separation from the assumed property line is less than 20 feet. c. Roof covering requirements should be shown on drawings, per IE3C table 1505.1. �. Tested materials and installation requirements for rated assemblies required between units should be fully identified on the drawing details, in addition to referencing the rated assembly number. The UL tested assembly is not located at the jobsite, and tl�e inspectors and contractor require the ieference materials full induded on the drawings issued for permit. Plan review cannot be completed without this informalion. a. For example, the partition type E, shown on A7.0, should indicate specific (proprietary or generic) materials which have been tested to meet the STC 50 ratings in the tested assembly, in addition to the one hour fire resistance rating, per IBC sections 1207.2 and IBC section 709.1 (4). 3. Nlinimum tread and maximum riser dimensions for stairs should be shown on the drawings at all building stairs, and at accessible routes, per IBC section 1009.4.2. 4. Handrail and guard details and dimensions should be shown on the drawings at all building stairs, and at the accessible routes, including heights, per IBC sedions 1012 and 1013. 5. Exteric: door hardware sets and common areas should be shown on the drawings to meet the requirements for new doors and should be identified on the door schedule to not require tight grasping, pinching or twisting of the wrist to operate, per IBC section 1008.9.1. 6. Compliance witli mechanical or natural ventilation, and exhaust requirements should be shown on the architectural dra�vings, per IBC section 1203.1 and IMC table 403.3 ventilation rates. 7. One hour fire resistant tested assemblies sfiould be sliown on the drawings for residential unit separation, including the STC and IIC rating requirements, and mechanical and lighting penetration details, per IBC sections 1Z07, 71�, 713, 709, and 4Z0.2 and 97_03. 8. Compliance with emergency escape windows shou!d be shown on the drewings per IBC section 1029. 9. Compliance with lempered glazing should be shown on the drawings per IBt ;ection 2406.4 Accessibility 1. The per building determination of minimum requirements for Type A, e, and accessible units should be shown in the code analysis as an application of lhe requirements cited in � �