1130 RAINIER AVE A 2018-01-01 MF Import

' + � 2. P�evious comment.• Please indicate a posted occupancy sign on the dra�ti�ings for the community room. The posted occupancy sign shouid be for the highest load anticipated for either an assembly use (if less than 49` or an assembly occupancy (if greater than 49), per IBC t� ble 1004.1.1. a. Tl�e posted occupancy sign fo� the comrnunity room requi�es calculatrons on tl�e d�aavings, refe�encing the occupant load for the fundion of the space, per IBC table 1009.1.1, and the posted occupancy sign referenced to the plans. b. Tlre occupant load of 100, sho�a�n on detail 1/A9.1, a exceeds [he highest capacity for standing room only at 5 sf per occupant net Fo� fhe area of the community room, per IBC ta6/e 1009.1. i. i. The plans for the community room should have additronal drmensiens to locate tl�e ivalls perpendicular to column lines 10-12. ii. The target to the plan detail 8/A5.1 is not a plan detail, but an e%vation. The area of the community �oom cannot be calculated with tlie information p�ovided on the plans. Egress i. Previous comment: An architecturel site plan is requirec for review, for compliance with the building and fire codes, per IBC 1101.2, and IFC Chapter 5. a. Please indicate all the improvements for accessible design and the accessible route, in their entirety on lhe architecturel site plan drawings, specificaliy within the property lines. i. Additional defails targeted to tl�e site plan, dimensions shown on the site plan, and enougl� information contarned on sheet A1.0 are requrred so that someone else could build it f�om this draiving �vithout furthe� consultafion. 1. The const�uction of the acrossible means of egress from Type A units, Type B units and the community room to the publrc ivay sllould be shown in their entirety on tl�e architectural site plvn. 1. Note: the use of lvrge arroi-v to sho�v fhe direction of travel are obscuring the construc[ion ot Ihe e%ments that n�ill be issued for building permit. 2. Previous commcnl: An illuminated eait sign should be shor; n on the drawings �•ahere more than lwo exils are required, per 18C section 1011.1 for the sliared pvtio. 3. Previous comment: Landings are required on both sides of egress doors or gates, per IBC sections 1008.1.5 and 1008.1.G. a. Landrngs at the pedestrian gates should be shoivn on the drawings. Accessibility 1. P�evious comment: If a higher level of compliance is selected by the architect, it will be reviewed for compliance with adopted state laws for compliance with that seleclion. Federal ADA regulations and sfanda�ds may be more �estrictive. The Americans with Disabilities Act is enforced by the Department of Justice. a. P,zase remove all drawing references to 'ADA' wifhin the property lines of the project, and replace ivith tlre term accessible; per IBC sectron 1102.1.