Laserfiche WebLink
EXHIBIT A <br /> SCOPE OF WORK <br /> f. Evaluate pile axial (and lateral) capacity, down drag and settlement performance <br /> based on an additional pile size compared to the current 16-inch diameter shown <br /> in the existing Phase 7 Geotechnical Report. This subtask will be necessary if the <br /> IBC design parameters support a larger(than 16-inch)pile. <br /> 2. Update existing Phase 7 Geotechnical Report. Prepare an updated report based on • <br /> seismic parameters to meet the 2009 IBC documents using applicable existing <br /> information from the original Phase 7 Geotechnical Report. Relevant existing <br /> information from the 2005 report includes: site conditions, geotechnical data, ground <br /> water conditions, pile driving methods and equipment, and soil corrosivity conditions. <br /> Eight (8) paper copies of a draft report and eight (8) paper copies of the final report will <br /> be provided to the City. <br /> 3. Document review. The geotechnical subconsultant will review the "95 percent" <br /> submittal of the plans and specifications to confirm consistency with the geotechnical <br /> design recommendations. <br /> Task 5. Permit Assistance <br /> At the direction of the City, the Engineer will provide limited engineering support for permitting <br /> services as described herein. It is understood that the City will take the lead role in obtaining <br /> permit extensions or new permits for the project as necessary, based upon previously obtained <br /> permits. This task addresses the following: <br /> 1. Evaluate existing project permits status. Update the list of all existing project permits <br /> and approval/expiration dates. <br /> 2. Provide engineering support to the City, as requested, for permitre-application and <br /> extension. Due to the difficulty in anticipating potential agency issues and review <br /> requirements for obtaining updated or replacement permits, the scope of this task is <br /> limited to the hours identified in the budget. Project permits obtained for the Phase 7 <br /> project in 2005 are identified in Table 1.. <br /> Table 1 <br /> Permit/Approval/Notification Agency <br /> 1. Section 404 of the Clean Water Act U.S.Army Corps of Engineers <br /> 2. Hydraulic Project Approval(HPA) . Washington Dept. of Fisheries <br /> 3. Section 401 Water Quality Certification and Washington Dept. of Ecology <br /> CZM Consistency Review <br /> 4. NPDES Permit Washington Dept. of Ecology <br /> MWH Page 4 EVERETT PHASE 7 <br /> 8/12/10 EXHIBIT A—SCOPE OF WORK <br /> 33 <br />