Laserfiche WebLink
2012 Washington State ey Code Compliance Forms for Commercial, Grousand>3 story R2 and R3 <br /> "Mechanical Summary, • • <br /> 2012 Washington State Energy Code Compliance Forms for Commercial Buildings including R2&R3 over 3 stories and all R1 Revised Aug 2015 <br /> Project includes HVAC air distribution systems that provide heating and/or cooling <br /> If yes,provide a MECH-FANSYS-SUM form. <br /> Fan Power <br /> For one or more systems,the total fan motor nameplate hp of all fans in HVAC system exceeds Shp. <br /> If yes,provide a seperate MECH-FANSYS form for each HVAC system exceeding the 5 horsepower threshold. <br /> Refer to Section C403.2.10 and MECH-FANSYS-DOC for requirements and exceptions. <br /> Commissioning Exception Commissioning will be provided for all applicable systems <br /> Summary Commissioning Exceptions: <br /> Not required per C408.2 exception.System qualifies as simple system,is not <br /> Describe means of eligibilty for required to have an economizer per section 403.3.1 and equipment capacity is <br /> commissioning exception(capacity, ❑� Mechanical system(s) less than 480,000 Btu/h cooling capacity and less than 600,000 Btu/h heating <br /> etc)for all systems noted as taking capacity <br /> exception in Mechanical Systems <br /> Summary table.Refer to Section 0 Service water heating Not required per C408.4.Service water heating system is less than 200,000 <br /> C408.2 and C408.4 for exceptions. system(s) Btu/h <br /> For systems requiring commissioning, Figure C408.1.2.1 Commissioning Compliance Checklist shall be submitted to the <br /> code official upon project completion. <br /> Low Energy and Semi-Heated Spaces (Note 6 and 7) <br /> Peak Space <br /> Heating Cooling Conditioning <br /> Space Area Served, Capacity,Btu/h Capacity,Btu/h Capacity, Compliance <br /> Type Location in Plan(s) Space(s)Served square feet (Note 4) (Note 5) Btu/h-sf Check Notes <br /> Note 4-Provide total installed heating output capacity of systems serving Low Energy or Semi-Heated space(s)in btuh. <br /> Note 5-Provide total installed cooling capacity of system serving Low Energy space(s)in Btu/h.Not allowed for semi-heated spaces.Enter 0 if no cooling. <br /> Note 6-Refer to Section C101.5.2 Low Energy Building.Intalled peak space conditioning capacity,heating or cooling,may not exceed 3.4 Btu/h-sf. <br /> Note 7-Refer to Section C402.1.4 and Semi-Heated Space definition in Chapter 2. Total heating output capacity may not exceed 8 btuh/sf. Only systems without <br /> electric resistance heating and no cooling are eligible for the wall insulation exception under semi-heated. <br />