Rodarte Construction Inc 2/14/2018

I disconnect, capping of lines and meter removals required within the Public Rights-of- Way. B. The Contractor shall meet with the Engineer to verify location of utilities with the Contractor's location services. To make arrangements the Contractor shall contact the Owners Representative to request the meeting and also arrange for underground utility location services by Everett Plumbing, Electrical, Sewer/Wastewater Shops and Environmental services staff for locates, site information and to request shut-off of pressurized or powered utilities. Verify that all appropriate services have been disconnected. C. Utility Shutoffs: Coordinate all work with other Division 1 requirements. Do not shut off or cap utilities without prior notice. Keep streets, sidewalks and site clean and free from debris at all times. Keep both street and site drainage systems open for free passage of runoff at all times. Provide siltation control and catch basin protection as required by Best Managements Practices and Drainage Codes as required and/or directed by the Engineer. D. Existing irrigation pipe shall be abandoned in the ground in locations where the pipe does not conflict with the proposed drainage and irrigation piping Work. In areas where existing irrigation pipe conflicts with proposed piping, the irrigation pipe shall be cut and removed completely from the site and disposed of. E. The disconnection of electrical equipment shall be done by a licensed electrician,prior to beginning electrical demolition. F. Existing site storm drains and cath basins, as indicated on the plans or as directed in the field, shall be kept open and operable at all times. Catch basins shall be protected from silt by filter fabric insert `sock' during construction, per Section 01 57 13. Catch basins or pipes that become blocked shall be cleaned immediately by the Contractor. G. Dispose of all waste material at an approved disposal facility. All efforts should be made to recycle concrete and asphalt materials. 3.02 REMOVAL OF EXISTING IRRIGATION HEADS: I A. Locate all existing irrigation heads within the limits of grading or as otherwise indicated on the contract drawings by the following means: 1. Contact the Owners Representative to request a preconstruction Irrigation Coverage Test for the facility under construction. Note the location of all operable irrigation heads and their respective Control Zones directly on the Record Drawings. 2. At the time of the above mentioned coverage test, and in consultation with the Engineer, refer to the drawings for locations of irrigation heads that may not be operating and hence may not have been visible during the test. Locate by hand digging as necessary. B. Carefully record the head locations and the remaining risers and swing joints by surveying their actual locations onto the record drawings. In addition, stake these Legion Golf Course Stormwater Detention Project November 30, 2017 WO#UP3620 02 41 13.23 -2