Ordinance 1119-85 - Laserfiche WebLink

F. Final Short Subdivision Submittal 1 . Compliance 'with Preliminary Approval: Prior to the submittal of any final short subdivision to the City for final approval, the applicant must demonstrate compliance with the conditions of _ the preliminary approval and prepare and complete to the satisfaction of the City all the final documents. 2. Short Plat: The final short plat drawings shall be on mylar drafting film having the dimensions of eighteen by twenty-four inches (18" x 24"). Information required shall include: a. The date, scale, and north arrow; b. Boundary lines, right-of-way for streets, easements, and property lines of lots and other sites with accurate bearings, dimensions or angles and arcs, and central angles of all curves; c. Names and right-of-way widths of all streets within the short subdivision and immediately adjacent to the subdivision. Street names will be consistent with the names of existing adjacent streets; d. Number of each lot and each block; e. Reference to private covenants or special plat restrictions either to be filed separately or on the face of the plat; f. Zoning setback lines, building sites when required by the City; g. Existing structures and all setbacks; h. Location, dimensions and purpose of any easements; i. Location and decription of monuments and lot corners set and found; j. Datum elevations and primary control points approved by the Public Works Department. Descriptions and ties to all control points will be shown with dimensions, angles, and bearings; k. The final short plat will also contain the following: (1) A certification by a Licensed Surveyor licensed in the State of Washington, that the plat survey is accurate and conforms to the provisions of these regula tions; (2) Certification by Public Works Department that are all conditions are met; (3) Certification by Planning Department that all conditions have been met; -20-