SRV Construction Company 5/1/2018

i CITY OF EVERETT SPECIAL PROVISIONS Work also includes abandoning existing service connection and service connection pipe in-place. Supplement 7-15.1 as follows: 7-15.1(1) Submittals (******) Provide Type 2 Working Drawings for all materials and Standard Plans. 7-15.2 Materials Delete first paragraph and material list of 7-15.2 and substitute the following: Provide materials meeting the requirements of the following sections: Saddles 9-30.6(1) Special Provisions Corporation Stops 9-30.6(2) Special Provisions Service Pipe 9-30.6(3) Special Provisions Service Fittings 9-30.6(4) Special Provisions Meter Setters 9-30.6(5) Special Provisions Meter Boxes 9-30.6(7) Special Provisions Brass Nipples and 9-30.6(8) Special Provisions Fittings 7-15.3 Construction Requirements1 Revise the first paragraph in 7-15.3 to read as follows: Provide new service connections to new water mains using specified saddles of the size and type suitable for use with the service pipe being installed. Install new service connection piping from the main to the meter box as shown on the Plans and directed by the City Inspector. Install service connection piping perpendicular to the main, unless shown otherwise on the Plans or directed by the City Inspector. Revise the second paragraph in 7-15.3 to read as follows: Provide trench depth adequate to maintain a minimum of 30-inches of cover over the top of the connecting service pipe. Exercise particular care to ensure that the main is not damaged by the Work undertaken to install the service. Excavate and backfill for service connections as specified in Section 7-09; except, use approved boring methods to install the service pipeline under cement concrete pavement, curbs, and sidewalks. Supplement 7-15.3 by adding the following: Provide service connections to water mains in accordance with COE Standard i Drawings No. 501 and 502 as applicable. Field verify actual service connection location, size and material as existing service information and locations shown on the Plans may not be accurate since this information is taken from existing records. Match the service size of the existing service connection with the minimum service size being 3/4-inch. Should the planned location require moving after verifying actual service connection in field, City Inspector and the City Utility Department personnel will make final decision as to its relocation. Replace existing services from the main to the property line, including the meter box and meter setting if noted on the Plans. Bore service connection lines, regardless of size, under pavement section, curbs and sidewalks where soil conditions and other existing buried utilities allow. The City Inspector will allow open-cut trench installation across pavement section, curbs and sidewalks only where soil conditions prohibit boring. Open—cut lawn areas and other non-pavement areas for service installation unless City Inspector directs otherwise. The City Inspector may, at the Contractor's request, allow tunneling under curb and Water Main Replacement"Q" Division 7—STORM,SEWER,WATER February 9, 2018 -Evergreen Way Rebid WO No.—UP3612 SP—160 ,