SRV Construction Company 5/1/2018

I CITY OF EVERETT SPECIAL PROVISIONS Assistants and inspectors may advise the Contractor of any faulty work or materials or infringements of the terms of the Contract; however, failure of the City's Representative or the assistants or inspectors to advise the Contractor does not constitute acceptance or approval. 1-05.3 Working Drawings Revise the second paragraph to read as follows: 1. Type 1 — Submitted for City information. Submittal must be received by the City a minimum of 7 working days before Work represented by the submittal begins. 2. Type 2 — Submitted for City review and comment. Unless otherwise stated in the Contract, the Engineer will require up to 15 working days from the date the Working Drawing is received until it is returned to the Contractor. The Contractor shall not proceed with the Work represented by the Working Drawing until comments from the Engineer have been addressed. 3. Type 2E — Same as a Type 2 Working Drawing with Engineering as described below. 4. Type 3 — Submitted for City review and approval. Unless otherwise stated in the Contract, the Engineer will require up to 20 working days from the date the Working Drawing is received until it is returned to the Contractor. The Contractor shall obtain the Engineer's written approval before proceeding with the Work represented by the Working Drawing. 5. Type 3E — Same as a Type 3 Working Drawing with Engineering as described below. Supplement 1-05.3 as follows: After Award of the Contract, the Contractor will receive up to six sets of the reduced Plans (11" x 17") and accompanying Special Provisions. In addition, the Owner will supply up to three sets of full size plans (22" x 34"). All Plans and Special Provisions will be conformed with addenda unless Contractor requests otherwise. Additional Plans and Special Provisions may be purchased by payment of the current printing costs. The Contract Documents include Plans that show such details as are reasonably necessary to give a comprehensive understanding of the Work. The Contractor shall submit alterations affecting the requirements and information in the Plans in writing to the Engineer for approval prior to performing such Work. I The Engineer may supplement the Plans with additional drawings and explanations, consistent with the purpose and intent of the original Plans, to detail and illustrate the Work. The Contractor shall perform the Work according to these supplemental drawings and explanations. In addition to supplemental drawings furnished by the Engineer, the Contract Documents may also be supplemented by Type 1, Type 2 or 2E, and Type 3 or 3E Working Drawings prepared by the Contractor, material supplier, or manufacturer, when necessary or as required by the Contract Documents to detail and illustrate portions of the Work. All types of Working Drawings shall be reviewed by the Engineer before work pursuant to those Working Drawings is performed. Type 3 and 3E Working Drawings may include, and not be limited to, shop details, erection plans, masonry lay-out diagrams, reinforcing steel and bending diagrams, post tensioning plans, shoring, cribbing, cofferdam, or falsework plans, formwork plans, or hydraulic Water Main Replacement"Q" Division 1 —GENERAL REQUIREMENTS February 9, 2018 -Evergreen Way Rebid WO No—UP3612 SP—58 i