Laserfiche WebLink
1 <br /> or Owner's Representative, or their related entities, any duty or authority to supervise or direct <br /> ' the performance of the Work or any duty or authority to undertake responsibility inconsistent <br /> with the provisions of the Contract Documents. <br /> ' 2.2 Division of Specifications and Drawings <br /> A. Specifications and Drawings are divided into groups for convenience. These divisions are not for <br /> ' the purpose of apportioning Work or responsibility for Work among Subcontractors, Suppliers and <br /> manufacturers. The Contractor is responsible for all Work shown or described, regardless of <br /> location(s)in the Contract Documents. <br /> 2.3 Discrepancies in Specifications and Drawings <br /> A. Errors and Omissions <br /> I1. If the Contractor, in the course of the Work, becomes aware of any errors or omissions in the <br /> Contract Documents or in the Owner's field work, he or she shall immediately inform the <br /> Owner's Representative in writing. The Owner's Representative will promptly review the <br /> ' matter and if he or she finds an error or omission has been made, then he or she will <br /> determine the corrective actions and advise the Contractor accordingly. If the corrective <br /> work associated with an error or omission significantly increases or decreases the amount of <br /> ' Work called for in the Contract, the Owner will issue an appropriate Change Order. After <br /> discovery by the Contractor of an error or omission, related work performed by the <br /> Contractor shall be done at its risk unless authorized by the Owner's Representative and <br /> approved by the Owner. Omissions from the Drawings or Specifications or the <br /> ' misdescription of details of Work that are manifestly necessary to carry out the intent of the <br /> Drawings and Specifications, or that are customarily performed, shall not relieve the <br /> Contractor from performing such omitted or misdescribed details of the Work, but they shall <br /> be performed as if fully and correctly set forth and described in the Drawings and <br /> Specifications. <br /> B. Conflicting Provisions <br /> ' 1. Figure dimensions on drawings shall govern over scale dimensions and detail drawings shall <br /> govern over general drawings. In the event an item of Work is described differently in two <br /> or more locations on the Drawings and in the Specifications, the Contractor shall, upon <br /> ' request of the Owner's Representative, submit in writing to the Owner's Representative the <br /> description upon which the Contractor relied in preparing its Bid or laying out the Work. If <br /> the Owner's Representative directs the Contractor to perform Work in a manner other than <br /> ' that contemplated by the Contractor in preparing its Bid or laying out the Work, Change <br /> Order procedures will be followed. In this event, the Contractor shall submit to the Owner's <br /> Representative such supporting information, including bidding or layout documents, as may <br /> ' reasonably be necessary for the Owner's Representative to determine whether the Contract <br /> Sum is increased, decreased or unchanged by the Change Order. <br /> C. Utilities <br /> ' 1. General <br /> a. The Owner has endeavored to determine the existence of utilities at the Site of the <br /> Work from the records of the owners of known utilities in the vicinity of the Work. The <br /> positions of these utilities as derived from such records are shown on the Drawings. No <br /> excavations were made to verify the locations shown for underground utilities. The <br /> service connections to these utilities are not shown on the Drawings. It shall be the <br /> ' PROCESS WATER PUMP STATION 06/13/2017 <br /> WO-3647 00 72 13 - 11 <br />