Laserfiche WebLink
( <br />4. Exit signs should be shown on drawings, per IBC section 1011.1. <br />Location ofnew and existing exitsigns are indicated on <br />sheetA3,1. Exitsigns have been added to rooms 134, 140, <br />159 and 169 and are shown bubb/ed. <br />5. Emergency lighting should be shown on drawings per IBC section <br />1006.1. Light fixtures with emergency battery back-up <br />ba//asts a�e indicated on Sheet A3.1. The retlectes/ ceiling <br />p/an /egend has been �evised to indicate that the symbo/ <br />for a hard wired "eyeba//� type emergency /ighring fixture <br />is not used since the �ecessed 2x4 fluo�escent fxtures wil/ <br />be uti/ized for this purpose. Refer io revised sheet A� 1. <br />6. Tactile exit signs should be shown on the drawings, per IBC section <br />1011.3. Tacti/e exit sign /a rations have been added to floo� <br />p/an 1/AZ.1. <br />Accessibiliiy <br />3. <br />The van accessible parking space{s) requires the following revision <br />to sheet Al.l: <br />• Signage: 60 inches above the floor of the parking space, <br />measured to the bottom of the sign, per ICC/ANSI A177.1-2003 <br />section 502.7. Dimension has been revised, see detai/ <br />4/AI.1. <br />Curb ramps should be shown on site plan Al.l to comply with the <br />landing requirements and slope requirements of ICC/NSI A117.1- <br />2003 section 406. Reference Everett Design and Construction <br />Standard drawing 310A. Additiona/info�mation has been <br />added to detai/ 3/A1.1. <br />The width of the accessible space adjacent to the new ramp should <br />be dimensioned as minimum 8 feet, per ICC/ANSI A117.1— 2003 <br />section 406. Dimension has been added to site p/an sheet <br />AZ.1. <br />4. Please identify and show the accessihle route on the � rawings for <br />the three accessible parking spaces located near the emergency <br />generator to the entry doors 100A and 167A, per ICC/ANSI <br />A117.1-2003 section 402. This information has been added to <br />t.he Site P/an 7/AI.1. <br />5. Vestibules 131.1, 167 and 168 should be dimensioned on the <br />drawings to indicate a clear space of 48 inches between doors in <br />the open position, per ICC/ANSI A117.1— 2003 section 404.2.5. <br />