Interwest Construction Inc 12/27/2018

I CITY OF EVERETT SPECIAL PROVISIONS 1 City's Representative are not required or obligated to consider or review a request for substitution and may, in their sole discretion and option, consider or review such I requests. If the offered substitution requires changes to or coordination with other portions of the Work, include, if any, drawings and details showing such changes. The Contractor I agrees to perform these changes as part of the substitution of material or Equipment at no additional cost to the City. Approval of a substitution request will not relieve the Contractor from responsibility for the efficiency, quality, and performance of the I substitute material or Equipment, in the same manner and degree as the material and Equipment originally specified. Reflect cost differential associated with a substitution in the offer. If the City approves the substitution, the Contract Documents will be I modified by a Change Order modifying the Contract Sum in the amount of the cost differential. 1-06.2 Acceptance of Materials I 1-06.2(2)B Financial Incentive Delete 1-06.2(2)B. 1-06.2(2)D Quality Level Analysis IDelete 1-06.2(2)D. 1-06.3 Manufacturer's Certificate of Compliance I Supplement 1-06.3 by adding the following: When authorized by the Standard Specifications or these Special Provisions and prior to use, the Engineer may accept certain Equipment on the basis of a Manufacturer's I Certificate of Compliance as an alternate to Equipment inspection and testing. A Manufacturer's Certificate of Compliance shall be reserved for cases where compliance to Contract requirements is not readily determinable through inspection I and testing of materials or Equipment. The Contractor shall provide properly authenticated documents to the City's Representative that the materials and Equipment comply with the Contract requirements. I The Contractor shall pay all associated costs of providing each Manufacturer's Certificate of Compliance submitted for City acceptance. The City reserves the right to refuse to accept Equipment on the basis of a 1 Manufacturer's Certificate of Compliance. 1-06.3(1) Inspection at Point of Manufacturing (******) I The Contractor shall be responsible to reimburse the City for the costs of inspections at the point of manufacturing for inspections occurring outside of Whatcom, Skagit, Island, Snohomish. King, Pierce and Thurston counties. Costs to be paid or I reimbursed by the Contractor include, but are not limited to, travel, subsistence, labor and lodging expenses of the City Inspector. Point of manufacturing inspection will be required if: I Inspection and testing of materials or Equipment in the vicinity of the Work by the City is not practicable, The Contractor requests the City to inspect and test material or Equipment at the point of manufacture, or I The Standard Specifications or these Special Provisions require that inspection, testing or witnessing of tests take place at the point of manufacture. I Watermain Replacement "T" Division 1 —GENERAL REQUIREMENTS October 10, 2018 IWO No—UP3684 SP—77