Rodarte Construction 4/29/2019 - Laserfiche WebLink

I CITY OF EVERETT SPECIAL PROVISIONS After trench backfill and compaction are completed, perform deflection testing if CCTV testing reveals thermoplastic pipe being out of round. 7-04.3(1)G2 Television Inspection After trench backfill and compaction are completed the City will use their CCTV camera to inspect the interior of mains and the interior of existing lines having Contractor installed new structures or side sewers or both. Provide the City with a three-business-day notice for each CCTV request. Begin final roadway surfacing AFTER notice from City Inspector of City Sewer Department approval of the CCTV inspection. ' Prior to arranging with City for CCTV inspection, perform the following: Clean lines and structures of all debris, Channel manhole inverts Adjust catch basin sump depth, where required in the plans Seal pipes entering structures according to these Special Provisions. Correct deficiencies noted by the City Inspector and the CCTV inspection results to the satisfaction of the Engineer. City will bear initial inspection costs. Contractor shall be responsible for re- inspection costs if CCTV equipment will not pass through the lines or structures on initial inspection. City will deduct cost for follow-up re-inspection after correction of deficiencies from Contractor's final payment on a direct cost basis. 7-04.3(1)H Final Acceptance City will require successful completion of the following items prior to issuing final acceptance, including, but not limited to: 1. Passing low pressure air testing. 2. Backfill and compaction in accordance with COE Standard Drawings No. 614, 615, and 620. 3. Line and grade to the tolerance of 7-08.3(2)B. 4. Manhole, inlet, and catch basin to the invert elevation, and cleaned. 1115. Manhole, inlet, and catch basin casting set to final grade. 6. Manhole, inlet, and catch basin construction in accordance with 7-05.3. 7. Lines free of debris and obstructions. 8. Bell and spigot joints properly seated as evidenced by successful completion of CCTV testing. 9. HDPE bead removal, where required, is accomplished without leaving sharp and jagged edges. I 7-04A Measurement Delete the first paragraph of 7-04.4 and substitute the following: I Bid items of Work completed pursuant to the Contract Documents will be measured as described in Division B — Bid Item Descriptions of these Special Provisions and Section 1-09 MEASUREMENT AND PAYMENT of the Standard Specifications. 7-04.5 Payment Delete all paragraphs in 7-04.5 and substitute the following: Payment for bid items of Work completed pursuant to the Contract Documents will be as described in Division B — Bid Item Descriptions of these Special Provisions and Section 1-09 MEASUREMENT AND PAYMENT of the Standard Specifications. 7-05 MANHOLES, INLETS, AND CATCH BASINS 7-05.1 Description Revise the first paragraph in 7-05.1 to read as follows: I Alverson Stormwater Separation February, 2019 WO No. -UP3660 Division 7—STORM, SEWER,WATER SP-154 I