6502 EVERGREEN WAY ENHANCED SERVICE FACILITIES 2020-01-21

Note 3-For proposed Fixture Description,indicate fixture type,lamp type(e.g. T-8),number of lamps in the fixture,and ballast type(if included). For track lighting,list the length of the track(in feet)in addition to the fixture,lamp,and ballast information. Note 4-For lighting equipment eligible for exemption per C405.4.1,note exception number and leave Watts/Fixture blank. Note 5-Existing-to-remain fixtures shall be included in the Proposed Lighting Wattage table in the same manner as new fixtures.Identify as existing in fixture description. Note 6-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.For luminaires with screw-in lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage).For low voltage lighting,enter the wattage of the transformer.For line voltage track/busway systems,enter the larger of the attached luminaire wattage or 50 watts/lineal foot,or enter the wattage limit of permanent current limiting device. Note 7-Proposed Wattage for each Building Area type shall not exceed the Allowed Wattage for that Building Area type. Trading wattage between Building Area types is not allowed under the Building Area Method compliance path. Note 8-Calculation Area Details: a.Lighting fixtures in a building addition may comply as a stand alone project,or they maybe combined with the overall existing building lighting systems to demonstrate compliance.Refer to C502.1. b.For alterations and building additions,provide Building Area types and gross interior areas in the Maximum Allowed Lighting Wattage table.If a building addition will comply as combined with the overall existing builidng lighting systems,include all applicable existing Building Area types and gross interior areas. c.If less than 50%of existing lighting fixtures will be replaced,use LTG-INT-SPACE form to document compliance.