Laserfiche WebLink
9-29 (PART A) Illumination, Signal, Electrical <br /> Section 9-29 is supplemented with the following general requirement: <br /> These Special Provisions (9-29 PART A) are based on Snohomish County requirements and apply to all <br /> work completed within the City of Bothell and the City of Everett, for the following bid items: <br /> "SR 527 at 208th Street SE (SR 524) Temporary Traffic Signal System, Complete." <br /> "SR 527 at 208th Street SE (SR 524) Traffic Signal Modifications, Complete." <br /> "Airport Road at SR 99 (Evergreen Way) Traffic Signal Modifications, Complete." <br /> "Airport Road at 112th Street SW Traffic Signal Modifications, Complete." <br /> "Airport Road at Kasch Park Road Traffic Signal Modifications, Complete." <br /> "Airport Road BAT Lane Illumination System, Complete" <br /> 9-29.1 Conduit, Innerduct, and Outerduct <br /> 9-29.1(1) Rigid Metal Conduit Fittings and Appurtenances <br /> Section 9-29.1(2)is revised asfollows: <br /> Delete "electroplated" from the first sentence. <br /> Paragraph one is supplemented with the following: <br /> Galvanizing repair paint requirements for conduit couplings shall also apply to end bushings. <br /> Add the following after the fifth paragraph: <br /> Conduit Coatings <br /> GRS Conduit fittings shall be coated with galvanizing repair paint in the same 39 manner as conduit couplings. <br /> Electroplated fittings are not allowed. <br /> Conduit entering concrete shall be wrapped in 2-inch wide pipe wrap tape with a minimum 1 inch overlap for 12 <br /> inches on each side of the concrete face. The tape shall have a synthetic rubber adhesive with a fungus inhibitor. <br /> Surface Mounting Conduit Attachment Components <br /> Conduit clamp shall be hot-dip,galvanized steel or stainless steel, and shall be one piece, two bolt units with <br /> locking nuts. The clamps shall be attached to the unistrut on both sides of the conduit with bolts and associated <br /> hardware. The minimum distance between adjacent clamps and between the clamp and the end of the unistrut shall <br /> be 1 inch. <br /> 31 <br /> Swift II BRT Boeing to Canyon Park Station-Traffic Signal 90%Special Provisions-12/1/2016 <br />