Laserfiche WebLink
TEST PARAMETER SPECIFICATION LIMITS <br /> Safe Heating Temperature 410° F <br /> Pour Temperature 38° F <br /> Penetration, 77° F, 6 oz, 5 sec. 10-25 dmm <br /> Penetration, 126 degrees F, 2 oz, 5 sec. 50 dmm max. <br /> Softening Point degrees F 410°F min <br /> Ductility, 125°F, in. 6°F min. <br /> Mandrel Bend, 0°F, 90°, <br /> 10 sec., 1/2 " diameter <br /> Pass 2 of 3 <br /> Case B <br /> Induction Loop Detectors installed and sealed into the pavement surface prior to finish lift <br /> of asphalt (or into a paving course which is to be resurfaced within one year) shall <br /> conform to this criteria: <br /> TEST PARAMETER SPECIFICATION LIMITS <br /> Safe Heating Temperature 421°F <br /> Pour Temperature 390°F max. <br /> Penetration, 77°F, 6 oz, 5 sec. 65 dmm <br /> Flow at 140°F (D3407) 0 <br /> Softening Point°F 210°F min. <br /> Resilience (D3407) 50% <br /> Penetration at 140°F 130% <br /> Case B shall be used unless otherwise specified on the Plans. <br /> The loop sealant shall be applied in accordance with the manufacturer's <br /> recommendations. <br /> Except as noted in the following pre-approved list of this Section, samples of each item <br /> shall be submitted to the Engineer for approval. <br /> Pre-approved list: <br /> • Crafco Loop Detector Sealant#34271 <br /> • 3M Detector Loop Sealant 5000 <br /> • DEERY Loop Sealant LW <br /> Item 12 is supplemented as follows: <br /> If the area around the conduit stub-out is greater than 2 inches in width, hot mix asphalt <br /> concrete shall be installed. <br /> Section 8-20.3(14)E is supplemented with the following: <br /> Signal standards shall be round tapered, not polygonal tapered. <br /> End 8-20.3(14) Signal Systems (PART A) <br /> Swift Green Line—Corridor Stations Special Provisions SP134 <br /> May 2017 <br />