Laserfiche WebLink
Passenger Fare Collection Equipment <br /> TICKET VENDING MACHINES <br /> Ticket Vending Machines are an owner-furnished and contractor-installed product. <br /> Manufacturer's installation procedures and product details in are provided in Appendix F-2. <br /> STAND ALONE FARE TRANSACTION PROCESSORS <br /> Stand Alone Fare Transaction Processors are an owner-furnished and contractor-installed <br /> product. Manufacturer's installation procedures and product details in are provided in <br /> Appendix F-3. <br /> Station Signage <br /> STATION NAME SIGNAGE <br /> Station Name Signage is an owner-furnished and contractor-installed product. <br /> Manufacturer's installation procedures and product details in are provided in Appendix F-5. <br /> RIDER ALERT BRACKETS <br /> Rider Alert Brackets are an owner-furnished and contractor-installed product. Manufacturer's <br /> installation procedures and product details in are provided in Appendix F-6. <br /> 8-31.3 Construction Requirements <br /> Station Shelter <br /> A. Station shelters shall be erected according to instructions provided by the manufacturer. <br /> B. Examination: Verify elevations of concrete and masonry bearing surfaces and locations <br /> of anchorages for compliance with requirements. <br /> C. Erect structural steel accurately in locations and to elevations indicated. <br /> D. Base and Bearing Plates: Clean concrete and masonry bearing surfaces of bond- <br /> reducing materials and roughen surfaces before setting base and bearing plates. Clean <br /> bottom surface of base and bearing plates and set on wedges, shims, or setting nuts as <br /> required. <br /> E. Tighten anchor bolts, cut off wedges or shims flush with edge of base or bearing plate, <br /> and pack grout solidly between bearing surfaces and plates. <br /> F. Maintain erection tolerances of structural steel within AISC's "Code of Standard Practice <br /> for Steel Buildings and Bridges." <br /> G. Install and tighten non high-strength bolts, except where high-strength bolts are <br /> indicated. <br /> H. Install and tighten high-strength bolts according to RCSC's "Specification for Structural <br /> Joints Using ASTM A 325 or A 490 Bolts." <br /> I. Connection Type: Snug tightened, unless indicated as slip-critical, direct-tension, or <br /> tensioned shear/bearing connections. <br /> J. Due to variations in the manufacturing process, Contractor should expect that minor <br /> adjustment will be required on approximately one-third (1/3) of the pre-drilled cladding <br /> panel holes in order to fit cladding panel over beam. <br /> Swift Green Line—Corridor Stations Special Provisions SP151 <br /> May 2017 <br />