Jansen Inc 6/10/2019 - Laserfiche WebLink

I I1 1-05.5 Tolerances 2 Geometrical tolerances shall be measured from the points, lines, and surfaces defined in 3 Contract documents. P 4 5 A plus (+) tolerance increases the amount or dimension to which it applies, or raises a 6 deviation from level. A minus (-) tolerance decreases the amount or dimension to which it I7 applies, or lowers a deviation from level. Where only one signed tolerance is specified (+ or 8 -), there is no specified tolerance in the opposing direction. 9 I10 Tolerances shall not be cumulative. The most restrictive tolerance shall control. 11 12 Tolerances shall not extend the Work beyond the Right of Way or other legal boundaries I13 identified in the Contract documents. If application of tolerances causes the extension of 14 the Work beyond the Right of Way or legal boundaries, the tolerance shall be reduced for 15 that specific instance. ▪ 16 ▪ 17 Tolerances shall not violate other Contract requirements. If application of tolerances causes 18 the Work to violate other Contract requirements, the tolerance shall be reduced for that I19 specific instance. If application of tolerances causes conflicts with other components or 20 aspects of the Work, the tolerance shall be reduced for that specific instance. 21 I22 1-05.9 Equipment 23 The following new paragraph is inserted before the first paragraph: 24 25 Prior to mobilizing equipment on site, the Contractor shall thoroughly remove all loose dirt I26 and vegetative debris from drive mechanisms, wheels, tires, tracks, buckets and 27 undercarriage. The Engineer will reject equipment from the site until it returns clean. 28 I29 This section is supplemented with the following: 30 31 Upon completion of the Work, the Contractor shall completely remove all loose dirt and 32 vegetative debris from equipment before removing it from the job site. ▪ 33 34 Section 1-06, Control of Material I35 January 7, 2019 36 1-06.1(3) Aggregate Source Approval (ASA) Database 37 This section is supplemented with the following: 38 ▪ 39 Regardless of status of the source, whether listed or not listed in the ASA database the 40 source owner may be asked to provide testing results for toxicity in accordance with 41 Section 9-03.21(1). 42 43 1-06.2(2)D Quality Level Analysis I44 This section is supplemented with the following new subsection: 45 46 1-06.2(2)D5 Quality Level Calculation — HMA Compaction 47 The procedures for determining the quality level and pay factor for HMA compaction are as I48 follows: 49 50 City of Everett Page AM-3 Amendments Everett Downtown Streetscape Improvement March 22, 2019