Ordinance 132-71 - Laserfiche WebLink

• to be done and the amount and kind in connection therewith, together with such information pertinent thereto as may be required. Such applicant shall pay for each permit issued at the time of issuance, a fee in accordance with the following schedule, and at the rate provided for each classification shown therein. Any person who shall commence any plumbing work for which a permit is required by this Code without first having obtained a permit therefor shall, if subsequently permitted to obtain a permit, pay double the permit fee fixed by this section for such work, provided however, that this provision shall not apply to emergency work when it shall be proved to the satisfaction of the Administrative Authority that such work was urgently necessary and that it was not practical to obtain a permit therefor before the commencement of the work. In all such cases a permit must be obtained as soon as it is practical to do so, and if there be an unreasonable delay in obtaining such permit, a double fee as herein provided shall be charged. For the purpose of this section a sanitary plumbing outlet on or to which a plumbing fixture or appliance may be set or attached shall be construed to be a fixture. Fees for reconnection and retest of existing plumbing systems in relocated buildings shall be based on the number of plumbing fixtures, gas systems, water heaters, etc. , involved. When interceptor traps or house trailer site traps are installed at the same time as a building sewer on any lot, no sewer permit shall be required for the connection of any such trap to an appropriate inlet fitting provided in the building sewer by the permittee constructing such sewer. When a permit has been obtained to connect an existing building or existing work to the public sewer or to connect to a new private disposal facility, backfilling of private sewage disposal facilities abandoned consequent to such connection is included in the building sewer permit. SCHEDULE OF FEES For issuing each permit $3. 00 For each plumbing fixture or trap including necessary water piping and back flow protection devices 2. 00 For each private sewage disposal system 10. 00 For each potable water heater 2. 00 For each industrial waste pretreatment interceptor 2. 00 For each grease trap or interceptor 2. 00 For each repair or alteration of drainage or vent piping 2. 00 For each lawn sprinkling system on any one meter or service, including backflow protection devices thereof 5. 00 For vacuum breakers or backflow protective devices on tanks, vats, etc. , or for installation on unprotected plumbing fixtures including necessary water piping - one (1) to five (5) 2. 00 Over five (5) - each . 50 Page 2